Garage door won't close: sensor repair in Guilford

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (475) 800-8480

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Guilford realigns or replaces the sensors and tests the safety reverse.

Opener, rail and torsion spring above a garage door with windows

Doors that won't close in Guilford

Guilford has one of the largest collections of historic houses in New England, and around Guilford Center many garages are old barns and carriage sheds with stone or dirt-patched floors, where the two sensors never sat level to begin with. At Sachem's Head, Leetes Island, Shell Beach and Indian Cove, salt and damp corrode brackets and connections, and summer cottages stand closed for months. In Nut Plains and around Guilford Lakes, mid-century and newer homes have ordinary attached garages. North Guilford is farmland and woods, with mice, leaves and long wire runs. A blinking light on one sensor is the clue to start with.

The usual reasons a door reverses or stays open

  • Misaligned photo-eyes. A bin, a bike tire or a broom knocks one bracket a few degrees and the beam misses.
  • Dirt, cobwebs or condensation on a lens. The sensor sees it as an obstacle.
  • Low sun shining straight into the receiving eye. It happens at the same hour each day and clears up later.
  • Damaged sensor wire. Staples, rodents and corrosion all break the thin low-voltage wire.
  • Close limit or force out of adjustment. The door reaches the floor and the opener reads it as a collision.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Guilford

  • Leetes Island and Shell Beach: Coastal areas on the eastern and western shore, with salt wear on door hardware.
  • Indian Cove: A shoreline neighborhood near the town center with a mix of older and rebuilt homes.

See the full Guilford service area.

Leave the door where it is and call.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (475) 800-8480
Call (475) 800-8480